1．混凝土地面在铺装地板之前，必须用砂浆C10提前15-20天找平，找平高度比地面设计高度低5mm。找平表面为光面。2．卷材地板对基础地面找平的平整度要求为每2米内的高低误差小于2毫米。3．混凝土及找平层必须充分干燥后才能安装卷材地板，一般需要15-20天后才能施工。整个地面含水率不超过5%。4．找平层须有足够的承载力，不能有裂缝，空鼓和起砂等现象。基层水泥强度必须大于10Mpa。5．基础地面需干净，无油脂、油漆、胶水、水泥硬块等。6．地脚线在地板安装完成后施工，施工中注意保护装好的卷材地面。
1. Before paving the concrete floor, mortar C10 must be used to leveling 15-20 days in advance. The leveling height is 5 mm lower than the design height of the floor. The leveling surface is smooth. 2. The flatness requirement for coil floor leveling is that the height error within 2 meters is less than 2 mm. 3. The concrete and leveling layer must be fully dried before installing the coiled floor, which usually takes 15-20 days before construction. The water content of the whole surface does not exceed 5%. 4. The leveling layer must have enough bearing capacity, no cracks, empty drum and sand. The strength of base cement must be greater than 10Mpa. 5. The base floor should be clean and free of grease, paint, glue and cement blocks. 6. Baseline shall be constructed after the installation of the floor, and attention shall be paid to the protection of the coiled floor during the construction.
塑胶地坪产品特性：由各种颜料橡胶颗粒或EPDM颗粒为面层，黑色橡胶颗粒为底层，由粘着剂经过高温硫化热压所制成，此产品环保且具有高度吸震力及止滑效果，减少从高处坠下而造成的伤害，提供大人或小孩在运动时的保护作用及舒适感。此种安全性地垫，长久耐用、容易清洁，适合铺设于室内外的地面适用于各种场地。
Characteristics of Plastic Floor Products: It is made of all kinds of pigments, rubber particles or EPDM particles as the surface layer, black rubber particles as the bottom layer, and adhesives through high temperature vulcanization and hot pressing. The product is environmentally friendly, has high shock absorption and anti-slip effect, reduces the damage caused by falling from high places, and provides protection for adults or children in sports. Function and comfort. This kind of safe floor mat is durable and easy to clean. It is suitable for laying indoor and outdoor floors on various sites.